您的位置: 首页 > 国外标准 > 美国材料与试验协会ASTM > 扁平皮带材料选择和使用的标准指南
 

扁平皮带材料选择和使用的标准指南

时间:2012/11/23

1.1 This guide covers information on flat strapping materials (steel or nonmetallic) for the prospective user wanting initial guidance in selecting a strapping material and applied configuration for use in packaging (closing, reinforcing, baling, unitizing, or palletizing) and loading (load unitization and securement to transport vehicle) applications. The use applies to handling, securement, storage, and distribution systems.

1.2 Carrier associations have established certain packaging and loading requirements that in some cases specify a type of strap, the minimum size or strength, or both, and type of joint or seal, or both, that must be used for certain types of shipments or under certain conditions. Users should consult with their carriers initially to determine if there are applicable, published requirements. Individual carriers may establish their own requirements (see 2.2 ).

1.3 Limitations8212;This guide is not intended to give specific information as to how strapping must be used in any particular packaging or loading situation. Rather it is intended to be informational in nature and is offered as a starting point for testing. The need for thorough user testing is to be emphasized as is a review of pertinent regulations that can influence the selection of sizes, types, and possibly, application methods.

1.4 The sections in this guide appear in the following order:

Section
Scope1
Referenced Documents2
Terminology3
Significance and Use4
Safety Hazards5
General Considerations:
Properties of Strap Types6
General Uses7
Strap Tension8
Packaging Design:
Distribution9
Package Configuration10
Strap Selection11
Joining Methods and Properties
Joint Methods and Properties (except loop joint)12
Loop Joint and Seal Properties13
Coatings:
Strap Coatings and Purposes14
Application:
Equipment for Strap Application15
Strap Application16
Testing and Evaluation:
Testing and Developing Final Package Design17
Evaluation of Strap Failure18
Keywords19
Supplementary GuidelineS1

1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific safety hazard statements are given in Section 5 and Note 1 and 15.3.

免费标准下载网 |标准分享网 |联系我们
版权所有:www.ZBGB.org