您的位置: 首页 > 标准信息  >  国外标准  >  国际标准化组织ISO  >  ISO 12494-2017  Atmospheric icing of structures
国内标准
国外标准
 

ISO 12494-2017  Atmospheric icing of structures

标准编号:ISO 12494-2017
分享到:

英文标准名称:Atmospheric icing of structures
首次发布日期:确认有效
语言:英文版, 中文版
发布日期:01 March 2017
标准类别:国际标准化组织ISO

标准页数:68
标准简介:ISO 12494:2017 describes the general principles of determining ice load on structures of the types listed in this clause.In cases where a certain structure is not directly covered by this or another standard or recommendation, designers can use the intentions of this document. However, it is the user's responsibility to carefully consider the applicability of this document to the structure in question.The practical use of all data in this document is based upon certain knowledge of the site of the structure. Information about the degree of "normal" icing amounts (= ice classes) for the site in question is used. For many areas, however, no information is available.Even in such cases, this document can be useful because local meteorologists or other experienced persons should be able to, on the safe side, estimate a proper ice class. Using such an estimate in the structural design will result in a much safer structure than designing without any considerations for problems due to ice.CAUTION It is extremely important to design for some ice instead of no ice, and then the question of whether the amount of ice was correct is of less importance. In particular, the action of wind can be increased considerably due to both increased exposed area and increased drag coefficient.ISO 12494:2017 is intended for use in determining ice mass and wind load on the iced structure for the following types of structure:- masts;- towers;- antennas and antenna structures;- cables, stays, guy ropes, etc.;- rope ways (cable railways);- structures for ski-lifts;- buildings or parts of them exposed to potential icing;- towers for special types of construction such as transmission lines, wind turbines, etc.Atmospheric icing on electrical overhead lines is covered by IEC (International Electrotechnical Commission) standards.This document is intended to be used in conjunction with ISO 2394.NOTE Some typical types of structure are mentioned, but other types can also be considered by designers by thinking in terms of which type of structure is sensitive to unforeseen ice, and act thereafter.Also, in many cases, only parts of structures are to be designed for ice loads because they are more vulnerable to unforeseen ice than is the whole structure.Even if electrical overhead lines are covered by IEC standards, designers can use this document for the mast structures to overhead lines (which are not covered by IEC standards) if they so wish.
标准关注次数:997
文件格式:纸质版或者PDF电子版(用Acrobat Reader打开)或Word版本doc格式
PDF格式 ISO 12494-2017  免费下载 Word格式 ISO 12494-2017  免费下载免费标准下载
文件大小:344KB
添加时间:2017/06/18
评论
序号
评论内容
用户名
日期
发表新评论 或 请提供可参考的全文下载链接
用户名
 
相关免费标准
 
 
本类标准下载排行
 
 
本类最新免费标准
 
免费标准下载网 |标准分享网 |联系我们 | 友情链接 |
版权所有:www.ZBGB.org   | 鲁ICP备09066343号-21